Up to 20 hours of moisture
•Contains 25% more Hyaluronan*
•Contains an added electrolyte and antioxidant to preserve balance of the ocular surface and to protect hyaluronan against free radicals
* vs original Biotrue MPS formula
•Triple Disinfectant System kills 99.9% of all germs tested**
Directions: To condition, clean, remove protein and disinfect lenses daily, complete these simple steps.
STEP 1: Place at least 3 drops of Biotrue® ADVANCED multi-purpose solution on each side of lens surface and gently rub for 20 seconds.
STEP 2: Thoroughly rinse each side of the lens for 5 seconds with Biotrue® ADVANCED multi-purpose solution.
STEP 3: Place cleaned contact lenses in the lens case and fill with fresh Biotrue® ADVANCED multi-purpose solution. Soak at least 4 hours. Remember to always use fresh solution – discard solution from lens case after each use. Your lenses are now ready to wear. If any debris remains on contact lenses, rinse with Biotrue® ADVANCED multi-purpose solution prior to insertion. Always follow your eye care professional’s instructions. Based upon your individual tear chemistry and lens-wearing schedule, your eye care professional may recommend additional products or procedures. If not wearing contact lenses immediately, store them in a closed lens case. Do not store your lenses or rinse your lens case in simple saline, tap or distilled water, saliva, or any non-sterile solution. These solutions will not disinfect. Not using the recommended disinfectant can lead to severe infection, vision loss or blindness.
IMPROPER USE OF CONTACT LENSES AND LENS CARE PRODUCTS COULD RESULT IN CORNEAL INFECTION AND/OR ULCER AND LEAD TO LOSS OF VISION.
Failure to discard solution from lens case after each use or use of water to care for your lenses may lead to contamination resulting in eye injury and potential loss of vision. See accompanying instructions for additional important safety information.
